Technology Offers
Search by categories
- Printing industry
- Plant engineering
- Building industry
- Polymer industry
- Process and production engineering
- Aerospace industry
3D printing of reinforcements made of fiber composite material
New additive manufacturing system from KIT prints complex reinforcement structures made of carbon fiber composite material quickly and efficiently using microwave radiation.
- Aerospace industry
- Automotive industry
- Electrical engineering
- Energy and water supply
- Energy technology
- Measurement technology
- Mechanical engineering
- Process and production engineering
- Automation / IT
- Simulation and data processing
Performance test for fuel cell systems
A new KIT fuel cell test bench simplifies the testing of complete fuel cell systems with interchangeable subcomponents.
- Automotive industry
- Building industry
- Coating technology
- Aerospace industry
- Raw material and textile industry
- Polymer industry
Measuring device for stress states in textiles
Biaxial test facility at KIT measures arbitrary stress and distortion states in flat membrane materials such as textiles and films.
- Automotive industry
- Aerospace industry
- Mechanical engineering
- Plant engineering
- Process and production engineering
- Building industry
XFRP springs with variable fiber combination
Springs made of a new type of fiber-plastic composite increase reversible energy absorption capacity through special combination and arrangement of the fiber materials.
- Aerospace industry
- Automotive industry
- Measurement technology
- Electrical engineering
- Environmental technology
- Forestry and agriculture
- Communication and data transmission
- Safety technology
Transmit signal separation for MIMO radars
Optimized MIMO technology improves resolution and dynamics for sensor networks for remote sensing and surveillance.
- Plant engineering
- Drive technology
- Aerospace industry
- Energy technology
- Process and production engineering
- Mechanical engineering
Aerodynamic film cooling holes
An optimized inlet geometry of film cooling holes on the cooling air side improves the film cooling effectiveness for cooling hot metal surfaces.
- Plant engineering
- Automotive industry
- Printing industry
- Polymer industry
- Process and production engineering
- Aerospace industry
3D microwave printer for continuous fiber reinforced polymer
A new system for additive manufacturing by using microwave heating to print components made of continuous fiber reinforced composites quickly and efficiently.
- Process and production engineering
- Microtechnology / precision mechanics
- Metal industry
- Aerospace industry
Deformation control for diffusion bonding
Optimized uniaxial diffusion bonding process allows deformation control when joining components with complex microstructures.
High-frequency sensor for non-contact torque measurements
Combination of a ferromagnetic sensor film and a high-frequency strip-line enables torque measurements.
- Process and production engineering
- Polymer industry
- Automotive industry
- Aerospace industry
- Metal industry
Loadable inserts in CFRP lightweight design
Novel inserts for CFRP sandwich structures allow cost-efficient manufacturing and require no subsequent joining steps.